Milling Jars Filling Levels; Replacing The Machine Fuses - VWR Star-Beater Manual De Instrucciones

INSTRUCTION MANUAL
Stopping the milling process:
• Stop the milling operation by pressing the START/STOP key.
Or
• When the milling time elapses, the milling process is automatically ended. The display is
reset to the last set value.
When removing and opening hot milling jars, always wear protective gloves.
There is a danger of burning the hands.

7.3. MILLING JARS FILLING LEVELS

Milling jar volume
1.5 ml
5 ml
10 ml
25 ml
35 ml
50 ml

7.4. REPLACING THE MACHINE FUSES

Milling sample
amount
0.5 ml
2 ml
4 ml
10 ml
15 ml
20 ml
The following fuses are required for Star-Beater:
2 x T2A 250V.
7
• Unplug mains plug from the mains socket 6.
• By pressing the locking device on the bottom side of the
6
fuse compartment 7, fuse holder is released and you can
pull it out.
• Replace fuses.
• Insert fuse holder and push it, until it locks.
Max. sample grain
size
1 mm
2 mm
4 mm
6 mm
7 mm
8 mm
EN 16
VWR Star-Beater
Balls max.
diameter
5 mm
10 mm
10 mm
15 mm
20 mm
25 mm