Harbor Breeze E-TM52BNK5CS Manual De Instrucciones página 11

WIRING
1c. FAN AND LIGHT CONTROLLED BY TWO
WALL SWITCHES: If you intend to control the fan
and light with separate wall switches, connect
BLACK wire from fan to BLACK wire from the
independent wall switch for the fan. Connect
BLUE wire from fan to the BLACK (or RED) wire
from the other independent wall switch for the
light. Connect WHITE wire from fan to WHITE
wire from ceiling. Connect GREEN wire together
from fan (on mounting bracked (A) and downrod
(O)) to BARE/GREEN wire from ceiling.
NOTE: BLACK wire is hot power for fan. BLUE
wire is hot power for light kit. WHITE wire is
common for fan and light kit. GREEN or BARE wire
is ground.
Wrap electrical tape (not included) around each
2.
individual wire connector (CC) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of
box from the black and blue (if applicable)
connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
CC E3 Wire Connector
3. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire
or electrical shock, do NOT use a full range
dimmer switch to control fan speed.
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
1c
2
CC
x 4
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
Lowes.com/harborbreeze
11
BLACK
BLACK (WALL SWITCH)
WHITE
GROUND/GREEN (BARE)
WHITE
WHITE
CC
CC
3
2
1
Speed
Switch