Amprobe GP-2A Manual De Uso página 20

6. When starting a measurement, if an interfering voltage higher than 9V is detected at
the ampere circuit's input, the instrument does not effect the test, emits a long sound
tone and displays the screen below
7. When starting a measurement, if an interfering voltage higher than 9V is detected at
both the ampere and volt circuits' inputs, the instrument does not effect the test, emits
a long sound tone and displays the screen below
8. If battery voltage is too low the instrument displays the symbol of low battery as well
as the message LOW BATT and no measurement is allowed. It is however possible to carry
out settings, reading of stored data, etc
9. The above said anomalous cases cannot be stored
(Too high input interfering voltage at volt circuit)
(Input interfering voltage value)
(Example under 2W mode)
(Example under 2W mode)
(Too high input interfering voltage at both ampere and
volt circuits)
(Input interfering voltage value)
(Example under 2W mode)
(Too low power supply, low batteries)
(Input interfering voltage value and distance set among
rods)
r
(Example under mode)
16