Troubleshooting Guide - BH FITNESS G2465 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Pressing the TEST button will take
you back to the main screen, where
the functions will be in the same mode
as when the TEST began.
Your fitness rating is a guideline that
shows you how fast your heart
recovers after physical exertion. If you
exercise regularly then you will see
your fitness rating improve.
The TEST will not work if you do not
have both hands placed on the hand-
grip sensors (R) Fig3 after you have
stopped doing the exercise.
If the error code "E1" is shown on the
screen then this means that you do
not
have
your
correctly on the hand-grip sensors (R).
If the error code "E2" appears on the
screen, this means that you have not
stopped exercising.
FITTING THE ELECTRONIC
MONITOR.-
Mod. G2465
Bring the monitor (1) to the handlebar
stem (31), connect the terminal (16)
coming out of the handlebar stem (31)
and the monitor (1), Fig.5A.
Take hold of the Hand-grip connector
(147), sticking out of the main post 31,
and plug it into located at the back of
the monitor (1).
Insert
the
monitor
handlebar stem (31), as shown in
Fig.5A, making sure not to pinch any
of the cables. Fit the bolts (13) along
with the fl at washers (14, 12), making
sure that the handlebar is aligned
correctly, securely tighten all of the
bolts on the handlebar.
Mod. H8715
Bring the monitor (2) to the handlebar
stem (13) Fig.5B, connect the two
terminals (16 / Q) coming out of the
hands
positioned
(1)
onto
the
handlebar stem (13) and the monitor
(2), Fig.5B.
Insert
the
handlebar stem (13), as shown in
Fig.5B, making sure not to pinch any
of the cables. Fit the bolts (8) along
with the flat washers, making sure that
the handlebar is aligned correctly,
securely tighten all of the bolts on the
handlebar stem.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function Works.
Solution:
a.-Make sure that the connection
cable is connected.
Problem: The monitor does not
switch on.
Solution:
a.-
Check
connections.
b.-Check the cable connections for
the main post.
Avoid leaving the electronic monitor
in direct sunlight as
damage the liquid crystal display.
Similarly, do not expose it to water or
knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
Do not hesitate to get touch with us if
you have any queries, by calling:
+44 0844 335 3988
service@bh-uk.co.uk
14
monitor
(2)
onto
the
monitor
this might
the
cable

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H8715

Tabla de contenido