Festo CPVSC-DN Breve Descripción página 24

Removing an existing node
4. In order to remove the ribbon
cable, do the following at the
same time:
On the base of the field bus
node: Press the locking hooks
4 in the direction of the
arrow.
Between the field bus node
and the valves: Press out the
plug of the ribbon cable.
Fitting a new node
1. Place the field bus node on the
valve terminal so that the inter
nal hook 2 locks into position.
2. Tighten screw 1 (see Remov
ing", step 1).
3. Push the plug of the ribbon
cable 5 on the base of the
valve terminal into the guide
until the locking hooks 4 lock
into position.
24 Festo CPVSC−DN 0404NH English
4
2
5