Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento página 20

Codec
The codec icon displays your currently selected 'record' codec or the 'playback' codec of the
file currently playing. You can select a new codec for recording by tapping the codec icon and
selecting from the menu options displayed on screen. For more codec information, see the
'record settings' section later in this manual.
Format
When in playback mode, the 'format' icon will display the current clips resolution and frame rate.
If you are in 'record' mode, it will display the resolution and frame rate of the current source
selected. If 'no signal' appears, it means a valid signal is not detected.
Timecode
A large timecode view at the top displays either SMPTE timecode or a timeline time counter.
Simply toggle between the two by tapping anywhere on the timecode icon.
The timecode view display SMPTE timecode or time counter.
Source
The source icon displays the current source input you have selected on the HyperDeck
Extreme 8K HDR. Tap on the source icon to open the record menu where you can select from
SDI, HDMI, Component and Composite.
Cache
If you are using the optional cache feature, you can see at a quick glance the storage remaining
and status of the cache by looking at the cache icon. When a M.2 PCIe NVMe disk is installed
and formatted, the cache icon will display the remaining space on the drive. When a valid video
signal is detected, the remaining space will be displayed in hours:minutes:seconds based on
the current format and your selected codec. When no valid signal is detected, the remaining
space available will be listed in TB or GBs.
If there is no SSD installed, the icon will display 'no cache'. For more details on using the
optional cache feature, see the 'Using the Optional Internal Cache' section later in this manual.
SMPTE timecode mode is indicated by a 'tc' icon to the right.
The time counter displays the timeline timecode.
The timecode display will appear red while the unit is recording in
both timecode and timecounter modes.
If you don't have a valid timecode source, the timecode for each
recording will begin at 00:00:00:00.
Touchscreen Display 20