Reference Signal; Selecting Your Devices; Controlling Your Playback And Record Decks - Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento

Reference Signal

The HyperDeck Extreme Control features reference in and reference out connections on the
rear panel to allow synchronous recordings.
If you are using an external reference source, connect your reference signal from the 'ref out'
of your reference device or deck to the 'ref in' on the controller.

Selecting your Devices

Now that your RS-422 devices and video signals are attached, it's time to select them on the
HyperDeck Extreme Control front panel. Choose you record and playback deck by selecting
the numbered soft button in the playback or record row.
1 On the front panel of the controller, press the button numbered '1' on the top row.
This selects the tape deck you previously connected into the first RS-422 connection
as your playback deck. The button surround will illuminate green.
Press number '2' button on the second row to select the HyperDeck Extreme 8K HDR
as your 'record' deck. The button surround will illuminate red to indicate this deck is
the recorder.
1 1 1 2 2
1 1 2 2 2
The green number 1 button indicated the playback deck,
IN OUT
the red button 2 indicates the recording deck.
Controlling your playback and record decks
INPUT PREROLL
Once your playback and record decks are connected and selected, you will be able to switch
control between the two by using the soft touch 'player' and 'recorder' buttons on the front
panel above the status indicators. When remote is enabled, you can then use the search dial
EDIT EJECT
and transport controls to navigate to the location on your deck.
1 Press the soft touch 'player' button and the player button will illuminate. The timecode
display and deck status indicator LEDs on the controller will update to show the ref,
servo and remote status of the playback deck. If you press 'recorder', the displays will
update to show the status of the HyperDeck recorder.
1 1 1 2 2 3 3 4 4
1 1 2 2 2 3 3 4 4
IN OUT ENTRY
DELETE
INPUT PREROLL SKIP
EDIT EJECT REW
When the 'player' button is selected, the timecode display will
update to match the deck selected as player. The deck status lights
will also update to reflect the settings of the connected device.
PLAYBACK
3 3 4 4 5 5 6 6
3 3 4 4 5 5 6 6
RECORD
ENTRY
TRIM
DELETE
SKIP REC
REW PLAY
PLAYBACK HOURS
5 5 6 6 7 7 8 8 M M
SHUTTLE
5 5 6 6 7 7 8 8 M M
RECORD
TRIM PLAYER RECORDER
REC SKIP
REF
SERVO
REMOTE
PLAY F FWD STOP
HOURS
7 7 8 8 M M
7 7 8 8 M M
PLAYER RECORDER
SKIP
REF
SERVO
REMOTE
F FWD STOP
MINUTES SECONDS FRAMES
JOG POSITION
HyperDeck Extreme Control Workflow
MINUTES SECONDS
SHUTTLE JOG POSITION
FRAMES
56