Connections To The Sequence Controller - Festo FSSC-12 Instrucciones De Utilizacion

Commander
Designation
L
IN
END
IN

6.3 Connections to the sequence controller

Connect the outputs A
FSS−12−C Quickstepper according to the following diagram (see also Fig. 3):
FSSC−12
Commander
outputs
A
P
A
X1
A
MAN
24
External signal input
External reset signal. The reset button on the Commander can be
blocked to limit the tripping location of the signal to the external
transducer (chapter 8).
External signal for stop after cycle end. Corresponds to the single
cycle setting on the Commander. When tripping the signal in run
ning automatic mode, the started cycle is ended.
on the rear of the Commander, to the inputs of the Festo
XX
FSS−12−C Function on the Quickstepper
Quickstepper
inputs
P Operating pressure. This connection is interrupted
when activating an external EMERGENCY−STOP
button.
X Triggering the first input. X
1
start of the sequence controller.
Press the start button: X
pressed air, the first work step is triggered on A
MAN/P Manual pre−select of the sequence controller via
the Auto/Man selector switch on the Commander.
With switch position MAN, set−up or step mode is
activated; with switch position Auto, automatic
operation is activated.
is always linked to the
1
is charged with com
1
Festo FSSC−12 0410a English
.
1