Stanley BOSTITCH N58N58C-1-E Manual Del Usuario página 6

70950_CoilNailing_Manual_Update
4. Swing the door/magazine cover closed. Check that the latch engages when released. (If it does not engage,
check that the nail heads are in the slot in the nose.)
TOOLS WITH A SAFETY TRIP- THREE OPERATING TYPES POSSIBLE.
All tools with a safety trip are marked with an inverted equilateral triangle (▼). Do not attempt to use a tool
marked in this way if the safety trip is missing or appears damaged.
SEQUENTIAL TRIP
(Reference 2 in Technical Data Table, column L)
The sequential trip requires the operator to hold the tool against the work with the safety
trip depressed before pulling the trigger. In order to drive additional fasteners, the trigger
must be released and the tool lifted away from the work, before repeating the above
mentioned steps. This makes accurate fastener placement easier, for instance on
GREY TRIGGER
framing, toe nailing and crating applications. The sequential trip allows exact fastener
location without the possibility of driving a second fastener on recoil, as described under
Contact Trip (below). The sequential trip tool has a positive safety advantage because it will not accidentally
drive a fastener if the tool is contacted against the work - or anything else - while the operator is holding the
trigger pulled.
CONTACT TRIP (N89C-1: SERIAL NUMBER 07315XXX ONWARDS)
(Reference 1 in Technical Data Table, column L)
The common operating procedure on "Contact Trip" tools is for the operator to actuate
the safety trip while keeping the trigger pulled, thus driving a fastener each time the
work is contacted. This will allow rapid fastener placement on many jobs, such as
sheathing, decking and pallet assembly. All pneumatic tools are subject to recoil when
BLACK TRIGGER
driving fasteners. The tool may bounce, releasing the safety trip and if unintentionally
allowed to re-contact the work surface with the trigger still actuated (finger still holding
the trigger pulled) an unwanted second fastener will be driven.
These tools are labeled with a "do not use on stairs or ladders" symbol. Technical Data Table Illustration.
Tools marked with this symbol must not be used where changing from one working position to another
involves the use of ladders, stairs or similar structures such as roof laths.
CONTINUOUS CONTACT OPERATION.
(Reference 4 in Technical Data Table, column L)
The Continuous Contact Operation Tools allow driving cycles to be repeated for as long as the trigger and
the safety trip remain actuated.
These tools may only be used where the length of the fastener does not exceed 65 mm. and they are also
labeled with a "do not use on stairs or ladders" symbol. See Technical Data Table Illustration. Tools marked
with this symbol must not be used where changing from one working position to another involves the use of
ladders, stairs or similar structures such as roof laths.
DIRECTIONAL EXHAUST DEFLECTOR (FIG. 4: N64-084, N64-099, N89C)
The adjustable exhaust deflector can be rotated to any desired position by hand without the use of any tools.
FASTENER DEPTH CONTROL ADJUSTMENT (FIG 5)
The Fastener Depth Control Adjustment feature provides control of the nail drive depth from flush with or just
above the work surface to shallow or deep countersink.
Warning! Disconnect tool from air supply before attempting any parts disassembly and before changing the
work contacting element adjustment.
1. Push in Locking Button
2. Adjust contact arm up to increase depth of drive or down to decrease it.
3. Release locking button.
7/6/07 17:52 Page 6