Safety; Safety Instructions; Additional Safety Instructions; Danger Of Electric Shock - ULTIMATE SPEED ULGD 5.0 A1 Traducción Del Manual De Instrucciones Original

Safety

Safety instructions

WARNING!
► Read all safety warnings and all instructions .
Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or
serious injury .
This charger is suitable for indoor
use only .
This appliance may be used by chil-
dren aged 8 over and by persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge, provided that they are
under supervision or have been told
how to use the appliance safely and
are aware of the potential risks . Chil-
dren must not use the appliance as a
plaything . Cleaning and user mainte-
nance tasks may not be carried out by
children unless they are supervised .
If the supply cord is damaged, it
■
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid
a hazard .

Additional safety instructions

Do not use the charger for charging
■
non-rechargeable batteries .
Do not use the charger for charging
■
lithium-ion batteries .
Place the removed battery in a well-
■
ventilated location during charging .
ULGD 5.0 A1
The automatic mode of opera-
■
tion and usage restrictions are
explained below in these operating
instructions .

DANGER OF ELECTRIC SHOCK!

Do not operate the appliance with
■
a damaged cable, supply cord or
mains plug . A damaged power
cord causes danger to life by elec-
tric shock .
Before connecting to the power,
■
ensure that the power connection is
earthed, is 230 V ∼, 50 Hz, and is
16 A fused and equipped with an
RCCB switch (residual current circuit
breaker) in accordance with the
current regulations!
Disconnect the charger from the
■
grid, before you make or break
connections to the battery .
Always connect the positive
■
terminal clamp (red)
The negative terminal clamp
■
(black) must be connected to the
chassis at least 10 cm away from
the battery and the fuel line .
Now connect the charger to the
■
power supply .
After charging, disconnect the
■
charger from the grid . Only after
this remove the clamp from the
bodywork . Following this, remove
the clamp from the battery .
first .
GB │ MT │ 33 ■