Look R96 Manual De Montaje página 13

EN
instaLLinG tHe ForK
The steering set cannot be dismantled
without special tools. Please call an
authorized LOOK retailer.
1
2
3
4
5
9
10
1. needle barrel
2. upper piston
3. steering spring
4. upper hinge
5. extraction bumper
6. aluminium insert
14
Torque : 8Nm
6
7
8
11
12
7. aluminium insert
8. lower hinge
9. direct absorber
10. lower piston
11. bearing bumper
12. needle barrel
The L96 is a single-piece frame. Its seat tube
is continuous to the saddle to optimize the
aerodynamics and rigidity whilst reducing
weight.
Fig. 1
The height of the seat tube was determined
according to your personal dimensions. The
height is therefore tailor-made and must not
be modified. Otherwise the warranty will be
lost.
To fit the carriage on the seat tube, please
refer to the corresponding paragraph. Be
sure to follow the fitting procedure and
tightening torques.
For your information, your saddle height
(defined when ordering) is obtained by
adding 7 spacers of 1 mm each between
the carbon carriage and the end of the seat
tube.
You have the possibility of removing the
7mm spacers to reduce the height of your
saddle by up to 7 mm (or adjusting with a
new saddle) or adding up to 7 mm of spacers
to increase the height of your saddle (or
adjusting with a new saddle).
adJustinG tHe HeiGHt
oF tHe saddLe