JVC TM-H1900G Manual De Instrucciones página 14

HOW TO INITIALIZE THE
SETTING
SCREEN DISPLAY AND SELECTIONS IN THE
<SET-UP MENU> RESET MODE
You can set <MENU> and <SET-UP MENU> screen items, picture adjustment items and
the volume level to their factory-set (initial) values.
1. Press the Power ( ) switch to turn the power
OFF (activate the standby mode).
POWER
2. While pressing both MENU button and CHROMA/
PHASE button, press the Power ( ) switch to turn
the power ON.
MENU POWER
CHROMA
PHASE
3. Setting
Initialization is required.
VOLUME/SELECT
Initialization is not required.
MENU
12
LCT1092-002A-H(EN)
The <SET-UP MENU> RESET screen is displayed.
Note:
● The <SET-UP MENU> RESET screen will not be
displayed if the MENU or CHROMA/PHASE buttons are
pressed for a very short time. Keep pressing them until
the display screen appears.
Press the VOLUME/SELECT [+] button.
* Initialization is completed, and the <SET-UP MENU>
RESET screen disappears.
Press the MENU button.
* Initialization is aborted, and the <SET-UP MENU>
RESET screen disappears.
14
<SET-UP MENU> RESET screen
<SET–UP MENU> RESET
Are you sure ?
"Yes" then <+>
"No" then <MENU>
Initial settings
Functions (Items)
SHARPNESS
ADJ. BAR POSI
COLOR TEMP
COLOR SYSTEM
RUSH DELAY
ASPECT RATIO
PICTURE SUB ADJ.
CONTRAST
BRIGHT
CHROMA
PHASE
H. POSITION
V. POSITION
WHITE BALANCE
R. CUT OFF
G. CUT OFF
B. CUT OFF
R. DRIVE
B. DRIVE
CONTROL LOCK
STATUS DISPLAY ON
REMOTE SYSTEM MAKE
INPUT REMOTE
CHROMA
PHASE
CONTRAST
BRIGHT
VOLUME
02.4.25, 9:49 AM
Initialization
(setting)
00
LOWER
6500
AUTO
STD.
4 – 3
00
00
00
00
00
00
00
00
00
00
00
OFF
A – B
00
00
00
00
20