Worx Trans4Mer WX540 Manual Del Usuario página 12

with the blade may result in personal injury.
Before you begin work, ensure the material
to be cut is rigid. Small workpieces should be
securely clamped to a work table.
1. SwITCHING ON aND OFF (See Fig. I)
For starting operation of the machine, press
the lock-off button (2) first, then press and
hold the On/Off switch (1) afterwards. To switch
off the machine, release the On/Off switch (1).
For safety reasons the On/Off switch of the
machine cannot be locked; it must remain
pressed during the entire operation.
2. HaND GRIP aREaS
Always ensure you maintain a firm grip while
operating your jigsaw.
3. PROTECTION FINGER
The finger is located in front of the blade
holder. While working, it will help prevent
accidental contact with the moving blade.
4. LED wORK LIGHT
A light (8) is built-in near the end of the
12
protection finger. The light will automatically
come on each time the on/off switch is
depressed.
5. CUTTING
waRNING: Always wear eye protection
while operating this power tool.
waRNING:
• Never hold the pivot head when operating
the tool.
• Never hold the motor cover when
operating the tool.
Before cutting any type of material, be sure
it is firmly anchored or clamped to prevent
slipping. Holding the work by hand or
against your body leaves it unstable and
may lead to loss of control.
• Place blade lightly against work to be cut,
depress the trigger switch and allow it to
obtain maximum speed before applying
pressure.
• Whenever possible, the saw foot plate
must be held firmly against the material
being cut. This will prevent the saw from
12V Li-ion multi-purposed saw
jumping or vibrating and minimize blade
breakage.
• Any cut which puts pressure on the blade,
such as angle or scroll cuts, increases
potential for vibration, kickback and blade
breakage.
waRNING: Shock hazard. Use extra
caution when cutting overhead and pay
particular attention to overhead wires which
may be hidden from view.
waRNING: Use extra caution when
cutting overhead and anticipate the path
of falling branches and debris ahead of time.
waRNING: Inspect work site for hidden
gas pipes, water pipes, or electrical
wires before making blind or plunge cuts.
Failure to do so may result in explosion,
property damage, electric shock, and/or
serious personal injury.
WORkiNg HiNTS fOR YOUR
mULTi-pURpOSED SAW
If your power tool becomes too hot, run no-
load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
GENERaL
Always use a blade suited to the material and
material thickness to be cut.
Always ensure the work–piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect
the quality of the cut. The blade cuts on the
upward stroke and may chip the uppermost
surface.
Ensure your uppermost surface is a non-
visible surface when your work is finished.
mAiNTENANCE
your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
EN