Heating System; Cooling System - Full Gauge V.03 Manual De Instrucciones

Example:
Temperature Setpoint: 30.0 °C (86 °F)
Exhauster 1 Relative Temperature:
Exhauster 1 Temperature Differential:
Exhauster 2 Relative Temperature:
Exhauster 2 Temperature Differential:
When average temperature rises
34.0°C (30°C + 4.0°C) , Exhauster 2 switches ON. If the temperature still keeps rising, the remaining fan groups will be turned ON according to each
individual setting. Exhauster 2 will switch OFF when temperature drops below
temperature drops below 31.0 °C (30.0 °C + 2.0 °C – 1.0 °C).

9.4 - Heating System

has 3 heating outputs that operate according to setpoint. It is possible to use all 3 temperature sensors, one for each
Humitech Super
heating output. Item 5.4 in this manual shows the distribution table of the heating outputs according to active sensors.
The control heating outputs operate as follows.
Las salidas de control de calefacción cuentan con la siguiente lógica de funcionamiento:
- When temperature is below the difference between the setpoint and the
output turns ON.
- When temperature crosses the abovementioned temperature plus the
output switches OFF.
Example:
Temperature Setpoint: 30.0 °C (86 °F)
Differential to Turn Heating 1Output ON:
Differential to Turn Heating 1 Output OFF:
Differential to Turn Heating 2 Output ON:
Differential to Turn Heating 2 Output OFF:
Differential to Turn Heating 3 Output ON:
Differential to Turn Heating 3 Output OFF:
Sensors 2 and 3 are enabled.
Since all temperature sensors are enabled, the Heating 1 output will use Sensor 1 as a reference point. Output 2 will use Sensor 2 and Output 3,
Sensor 3.
When Temperature 1 drops below 25.0 °C (30.0°C + (-5.0°C))
5.0 °C + 1.0 °C) , Output 1 switches OFF.
When Temperature 2 drops below 30.0 °C (30.0°C + (-0.0°C))
°C + 1.0 °C) , Output 2 switches OFF.
below 35.0 °C (30.0 °C + 5.0 °C)
When Temperature 3 drops
+ 1.0 °C) , Output 3 switches OFF.

9.5 - Cooling System

The Cooling output is designed to operate a SprinklingAir-Cooling Evaporation System and it is controlled both by temperature and humidity.
-When average temperature is above the difference between the setpoint and the
output switches ON in cyclic mode, according to the settings configured in the parameters
OFF Time".
-When the average temperature drops below above mentioned temperature minus the
corresponding output switches OFF.
If at any time the Cooling is ON and air humidity crosses the value configured in
output is turned OFF. The output is turned ON again only if the humidity drops below
Humidity Differential to Restart Cooling".
Example:
Temperature Setpoint: 30.0 °C (86 °F)
Differential to Turn Cooling ON:
Differential to Turn Cooling OFF:
High Humidity to Force Cooling OFF:
High Humidity Differential to Restart Cooling:
Cooling Output ON Time: 15 seconds
Cooling Output OFF Time:
When the average temperature is
OFF (30 seconds) alternately. When the temperature is
above 80.0% RH during the Cooling process, the Cooling output remains OFF until the humidity falls
20 °C (68 °F)
1.0 °C (33.8 °F)
40 °C (104 °F)
1.5 °C (34.7 °F)
above 32.0 °C (30.0 °C + 2.0 °C)
-5.0 °C (23 °F)
1.0 °C (33.8 °F)
0.0 °C (32 °F)
1.0 °C (33.8 °F)
5.0 °C (41 °F)
1.0 °C (33.8 °F)
, Heating 1 output switches ON. If Temperature 1 rises
, Heating 2 output switches ON. If Temperature 2 rises
, Heating 3 output switches ON. If Temperature 3 rises
10.0°C (50 °F)
1.0 °C (33.8 °F)
80.0% RH
5.0% RH
30 seconds
above 40.0 °C (15.0 °C + 10.0 °C)
below 39.0 °C (30.0 °C + 10.0 °C - 1.0 °C)
, Exhauster 1 switches ON. If the temperature keeps increasing and
32.5 °C (30 °C + 4.0 °C - 1.5 °C)
"Differential to Turn the Heating Output ON"
"Differential to Turn the Heating Output OFF"
"Differential to Turn the Cooling ON"
"Cooling Output ON Time"
"Differential to Turn the Cooling OFF"
"High Humidity to Force Cooling OFF"
"High Humidity to Force Cooling OFF"
, the Cooling output enters the cyclic operation, turning ON (15 seconds) and
, the output switches OFF. If the air humidity rises
below 75% RH (80% RH - 5% RH).
38
reaches
and Fan Group 1 will turn OFF when
, the corresponding
, the corresponding
above de 26.0 °C (30.0 °C -
above 31.0 °C (30.0 °C - 0.0
above 36.0 °C (30.0 °C + 5.0 °C
, the corresponding
and "Cooling Output
, the
, then the Cooling
minus "High