Princess 242124 Manual Del Usuario página 21

• Put the flexible tube (24) into the milk jug.
Make sure that the flexible tube (24)
reaches the bottom of the milk jug.
• Press the on/off button (1) to switch on the
appliance.
• Briefly press the start/stop button (2) to
start the deventilation. During start-up, the
number of rinsing cycles required is established
electronically. If several rinsing cycles are
required, the process will be aborted every
45 seconds and the start/stop button (2)
will flash green. If necessary, empty the cup
and press the start/stop button (2) again.
The start/stop button (2) will illuminate red
when the appliance has been rinsed
sufficiently.
• Set the locking collar (8) to position 'B'.
The water is heated until the start/stop
button (2) changes from red to green after
approximately 80 seconds.
Use
Designation of the indicators
Component Indication
Start/stop button (2) Red
Red flashing
Green
Green flashing Preparation in
Water level Yellow flashing Fill the water
indicator (3)
Steam indicator (4) Yellow flashing Descale the steam
Yellow
Descaling Yellow flashing Descale the appliance.
indicator (5)
Yellow
program is running.
Switching on and off (fig. A)
• To switch on the appliance, press the on/off
button (1). The start/stop button (2)
illuminates red. The start/stop button (2)
illuminates green when the appliance is
ready for use.
• To switch off the appliance at any time,
press the on/off button (1) again.
Pre-brewing function
The pre-brewing function makes sure that the
appliance initially only supplies a small quantity
of water. The coffee-making process continues
after a short interval.
Economic brewing function
If you want to switch off the appliance after
preparing a beverage, the economic brewing
function can be activated automatically. To
activate the economic brewing function, keep
the start/stop button (2) pressed. The start/
stop button (2) illuminates green. The water
level indicator (3), the steam indicator (4) and
the descaling indicator (5) briefly flash yellow
after approximately 3 seconds. The economic
brewing function has been activated. If the
brewing process is completed, the appliance
Designation
will not heat anymore. The appliance switches
The appliance is
off automatically.
heating or rinsing.
Stand-by mode
Stand-by mode.
If the appliance is not used for more than
The appliance is
approximately 5 minutes, the stand-by mode is
ready for use.
activated automatically. The start/stop button
(2) flashes red. To activate the appliance for use,
progress.
press the start/stop button (2) again. If you turn
the cup size selector (6) or the beverage selector
reservoir.
(7) or if you fill the water reservoir (17) with
water, the stand-by mode is deactivated
device.
automatically.
Active steam mode.
Automatic switch-off function
/ Water hardness
The appliance switches off automatically if it is
setting mode.
has not been used for a period of 30 minutes.
The descaling
Water level indicator (fig. A)
The fresh water supply is monitored
continuously by a float which moves up and
down in the water reservoir (17). The water
level indicator (3) flashes when the level comes
below the required minimum filling quantity.
21