Kohler K-T16237 Guia De Instalacion página 4

1-1/4"
(3.2 cm)
2. Install the Spout Supply Tube
Remove the plaster guard from the spout supply tube.
Ensure that the spout supply tube projects a minimum of 1-1/4"
(3.2 cm) above the finished deck.
Using a file, remove all burrs from the spout supply tube. This
will prevent damage to the O-ring inside the sleeve.
For tile-covered deck installations: With the flat side of the
washer facing the edge of the finished deck (as shown), slide the
washer onto the spout supply tube. For all other installations:
Discard the brass washer.
NOTE: Before installing the spout sleeve assembly, make sure the
O-ring is properly positioned in the groove on the outside of the
sleeve.
Loosen the setscrews in the spout sleeve assembly.
Using a twisting motion, slide the spout sleeve assembly onto the
spout supply tube until it contacts the finished deck.
Align the spout sleeve assembly with the setscrews offset from
the center (not facing directly forward or backward) of the spout
supply tube.
Retighten the setscrews.
Purge the spout supply tube of debris.
1054538-2-C
Setscrews
Washer
Spout
Finished
Supply Tube
Deck
4
Spout Sleeve
Assembly
Finished
Deck
Kohler Co.