Emptying The Pulp Container And The Filter - Silvercrest SFE 450 C3 Manual Del Usuario

NOTE
Add carrots one after the other into the feed tube 2: the top of the carrot
►
must be at the bottom and the pointed end at the top.
NOTE
To avoid fruit or vegetables becoming blocked in the feed tube 2, only
►
fill it when the appliance is switched on. If fruit or vegetable pieces get
stuck in the feed tube 2 and cannot be promptly freed with the pusher 1,
proceed as follows to avoid damage to the appliance:
3) Always switch the off appliance immediately after all of the fruit/vegetables
have been processed.
CAUTION! PROPERTY DAMAGE!
To avoid blockage of the juice outlet 6 and/or damage to the appliance,
►
clean the juice outlet 6 and the juice tank 5 regularly and after every use.
Emptying the pulp container and the filter
■ You can extract juices continuously until the container for fruit and vegetable
pulp q is completely full.
WARNING! RISK OF INJURY!
Remove the plug 8 from the power outlet when emptying the filter w.
►
This prevents unintentional starting of the appliance.
If the extracted juice suddenly starts getting thicker, or if you hear that the motor is
running more slowly, the filter w needs to be emptied. When you have removed
the fruit pulp, reassemble the appliance.
SFE 450 C3
–
Switch the off appliance immediately and pull the power plug 8
from the wall socket.
–
Undo the clamps 4 and remove the lid 3.
–
Remove the fruit or vegetable pieces causing the blockage.
–
Reassemble the appliance and continue with juice extraction.
GB │ IE │ 11 ■