Troubleshooting - Silvercrest SFE 450 C3 Manual Del Usuario

Troubleshooting

Faults
The appliance is
not working.
The motor stops
still while juicing or
it turns noticeably
more slowly or
unevenly.
The pulp is moist
and you obtain too
little juice.
The juice wells out
between the edge
of the lid 3 and
the juice tank 5.
The juice sprays
out of the juice
outlet 6.
During the
processing, juice
runs down the
appliance base
7.
■ 14 │ GB │ IE
Possible causes
The mains plug 8 is not
connected.
The appliance is not switched on. Switch the appliance on with
The clamps 4 are not secured.
The filter w is blocked.
You are working too fast.
The filter w is blocked.
You are working too fast.
The filter w or the juice tank 5
is blocked.
The speed setting is too high.
You are working too fast.
The speed setting is
too high.
The filter w or the juice outlet 6
is blocked.
The speed setting is too high.
Possible solutions
Connect the appliance to
a mains power socket.
the On/Off switch 9.
Close the clamps 4.
Switch the juicer off immediately
and pull out the mains plug 8.
Remove the blockage (see sec-
tion "Juicing").
Work a little more slowly.
Clean the filter w (see section
"Cleaning and Care").
Work a little more slowly.
Clean the filter w and
the juice tank 5 (see section
"Cleaning and care").
Use the on/off switch 9 to
select speed level 1.
Work a little more slowly.
Do not press too hard with the
pusher 1 when inserting more
fruit/vegetables.
Use the on/off switch 9 to
select speed level 1.
Clean the filter w and the juice
outlet 6 (see section "Cleaning
and Care").
Use the on/off switch 9 to
select speed level 1.
SFE 450 C3