EINHELL BT-MC 355 Manual De Instrucciones Original página 18

Anleitung_BT_MC_355_SPK7__ 19.10.12 10:38 Seite 18
GB
Press down the handle (2) firmly and evenly
n
during the cutting operation.
To prevent overheating of the workpiece and
n
excessive formation of burr, you should not
reduce cutting speed at the end of the cutting
operation.
Note: The number of cuts per cutting-off wheel
and their quality may vary considerably with the
time taken to make the cuts. Fast cuts may
accelerate wheel wear, but they also prevent
discoloring of the workpiece and the formation of
burr.
8. Maintenance
Caution! Pull out the power plug first.
n
Remove dust and dirt regularly from the
n
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
n
18