Items Supplied; Proper Use - EINHELL BT-MC 355 Manual De Instrucciones Original

Anleitung_BT_MC_355_SPK7__ 19.10.12 10:38 Seite 15
This will only lead to premature wear and result
in poor cuts or a broken cutting-off wheel.
21. Workpieces are best cut when their angle in
relation to the cutting-off wheel is kept as small a
possible.
22. The number of cuts per cutting-off wheel and
their quality may vary considerably with the time
taken to make the cuts. Fast cuts may accelerate
wheel wear, but they also prevent discoloring of
the workpiece and the formation of burr. This
requires particular attention when cutting thin-
walled tubes. Do not reduce the cutting speed
toward the end of the cut, but cut right through to
the end with full power. This will help to prevent
the material from overheating and forming burr.
23. Always use the guard over cutting-off wheel.
24. Never use the machine in the vicinity of
combustible liquids or gases.
25. To avoid electric shocks, never use the machine
in damp or wet locations, and never expose it to
rain.
26. This electric tool was developed exclusively for
cutting ferrous metals. Do not try to cut wood,
brick or magnesium on this machine.
27. Do not stand in the cutting direction after a new
cutting-off wheel has been fitted. Allow the
machine to run for approximately one minute
before you begin with the cutting. If the cutting-
off wheel has an invisible fracture or defect, it will
burst in less than one minute.
28. Switch off the power supply before you carry out
any maintenance or adjustment work on the
machine.
29. Should any part of your machine be missing,
damaged or out of order in any way, or should
any electrical components fail to work correctly,
switch off the machine and pull the power plug
out of the socket-outlet. Replace the missing,
damaged or defective part before you carry on
with your work.
30. In the case of cutting-off wheels with straight-
sided flanges, be sure to observe the
recommend values for thickness and hole
diameter.
1. Layout (Fig. 1/2)
1 Saw head
2 Handle
3 Adjustable guard for the cutting-off wheel
4 Adjustable clamping face
5 Spindle
6 Hand crank
7 Stationary clamping face
8 Carry handle
9 Shaft lock
10 ON/OFF switch
11 Cutting-off wheel
12 Table
13 Locking device
14 Overload switch
15 Vise
16 Lock screw
17 Lock screw

2. Items supplied

Metal cutting-off machine
n
Cutting-off wheel for steel
n
Open-ended wrench
n

3. Proper use

The metal cutting-off machine is designed for cutting
metal commensurate with the machineʼs size.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse.
The machine is to be operated only with suitable
cutting-off wheels. It is prohibited to use any kind of
saw blade made of HSS, HM, CV, etc.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about the machineʼs potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
GB
15