Technical Data - EINHELL BT-MC 355 Manual De Instrucciones Original

Anleitung_BT_MC_355_SPK7__ 19.10.12 10:38 Seite 16
GB
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Contact with the cutting-off wheel in the un-
n
covered cutting zone.
Reaching into the cutting-off wheel while it is
n
running (injuries through cutting).
Kick-back of workpieces and parts of work-
n
pieces.
Broken cutting-off wheels.
n
Catapulting of damaged or cutting-off wheels.
n
Damage to hearing if ear-muffs are not used as
n
necessary.

4. Technical data

AC motor
Power P
Idle speed n
0
Cutting-off wheel
Footprint
Swiveling range
Vise clamping range max.
Saw width at 90°
Saw width at 45°
Weight
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
16
230 V ~ 50 Hz
2550 W
3800 min -1
Ø 355 x Ø 25.4 x 3.2 mm
480 x 277 mm
0 - 45°
195 mm
Ø 70 / 105 x 45 mm
85 x 45 mm
17.5 kg
101 dB(A)
3 dB
114 dB(A)
3 dB
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
5. Before putting the machine into
operation
Unpack the metal cutting-off machine and check
n
it for damage which may have occurred in
transit.
The machine has to be set up where it can stand
n
firmly, e.g. on a work bench, or it must be bolted
to a strong base.
All covers and safety devices have to be pro-
n
perly fitted before the machine is switched on.
It must be possible for the cutting-off wheel to
n
run freely.
Before you actuate the ON/OFF switch, make
n
sure that the cutting-off wheel is correctly fitted
and that the machineʼs moving parts run
smoothly.
Before you connect the machine to the power
n
supply, make sure the data on the rating plate is
the same as that for your mains.
Release the (13) locking device.
n
6. Assembly
Important. Always pull out the power plug before
carrying out maintenance, resetting or assembly
work.
6.1 Transport brace / carry-handle (Fig. 1 / 2)
Push saw head (1) down with the handle (2) and
n
pull out the locking device (13).
Slowly raise the saw head (1).
n
Caution! The resetting spring lifts the saw head
(1) automatically. Therefore, do not simply let go
of the handle (2) after cutting, but allow the saw
head (1) to rise slowly by applying slight
counterpressure.
Fig.1 shows the saw head (1) in its upper
n
position.
For transporting, the saw head (1) should be
n
locked in the lower position with the locking