Maintenance; Troubleshooting - JVC KV-MR9000 Manual De Instrucciones

MAINTENANCE

To prevent damage to the exterior
• Do not apply pesticides, benzine, thinner or other volatile substances to the unit.
The cabinet surface primarily consists of plastic materials.
• Do not wipe with benzine, thinner or similar substances because this will results in
discoloration or removal of the paint.
• When a cloth with a cleansing chemical is used, follow the caution points.
– Do not leave the unit in contact with rubber or vinyl products for long periods of time.
– Do not use cleansers which have polishing granules because this could damage the
surface of the unit.
Clean off dirt by wiping lightly with a soft cloth
When the unit is very dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral)
thinned by water and then go over the same surface with a dry cloth.
(Since there is the possibility of water drops getting inside of the unit, do not directly apply
cleanser to the surface.)
Caution:
If water drops or similar wet substances get inside of the monitor via the liquid crystal panel surface,
it may cause a malfunction.

TROUBLESHOOTING

What appears to be trouble is not always serious. Check the following points before calling a
service center.
Symptoms
• Colored spots (red, blue and
green) appear on the screen.
• No picture appears and sound
is not heard.
• Picture shakes vertically or
colors are abnormal.
• Remote controller does not
work.
• Cordless headphones (not
supplied) do not work.
14
Causes
This is a characteristic of liquid
crystal panels and is not a
malfunction.
Correct input mode is not
selected.
The video format (NTSC/PAL) is
not correct.
The battery has lost its charge.
Remote sensor is exposed to
strong light.
Remedies
See "Note" on page 15.
Select the correct input mode.
Select the correct video format.
Install a new battery.
Do not expose the remote
sensor to strong light.