JVC KV-MR9000 Manual De Instrucciones página 9

3
Monitor Remote
4
Play back the external component.
To operate the external components, refer to the manuals for the connected
components.
5
Select the external component and adjust the volume on the car
receiver.
To check the current input source
On the monitor: Press the Power button (
On the remote: Press the MODE button once.
The on-screen display appears for about 5 seconds.
To turn off the power
Close the liquid crystal panel.
• You can also turn off the power by holding the Power button (
on the unit, or by pressing the Power On/Standby button (
on the remote control briefly.
Select the video format—NTSC or PAL, while
the indication of the video format is still on the
screen.
Each time you press the button, the video format
alternates between NTSC (initial setting) and PAL. Select
whichever matches to the incoming signals.
Note:
When not using the KV-C10: You can preset the video format
separately for "AV 1" and "AV 2."
) once.
MODE
Monitor Remote
)
)
Monitor Remote
9