Relabeling recordings
1
Insert a disc and do the following
operations:
To relabel a track
Start playing a track you want to
relabel, and change a track name
during playback operation.
To relabel a group
Turn group mode on (page 30) and
start playing or recording a track
within the group you want to relabel,
and change the group name while
playing or recording operations.
To relabel a disc
If the disc is already recorded, follow
the procedures from step 2 while the
recorder is stopped.
If you relabel a disc with group
settings, turn group mode on
(page 30).
2
Follow steps 2 to 4 of "Labeling
recordings" (page 40) to display a
track, group, or disc name.
3
Follow steps 5 to 7 of "Labeling
recordings" (page 40), and then keep
pressing ENTER for 2 seconds or
more.
Notes
• You cannot relabel premastered MDs.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.
To cancel labeling
Press CANCEL.
Registering tracks or
groups as a new group
(Group Setting)
Do the following procedure to register
tracks or groups as a new group. The
tracks or groups must, however, be
sequential. If the desired tracks or groups
are not consecutive, you must move them
to make them consecutive before you can
register them ("Moving recorded tracks",
page 43). The operation of this function
depends on whether group mode is on or
off.
• When group mode is ON:
Several groups are registered as one
group.
• When group mode is OFF:
Several tracks are registered as one
group.
The following section explains the
operation when group mode is on.
1 2 3 4 5 6 7 8 9
Making a new
group with
tracks 1 to 3.
Group
1 2 3 4 5 6 7 8 9
• Registration of non-consecutive tracks
is not possible (for example, track 3
cannot be registered into a group with
track 5 to 7).
• Tracks always appear according to their
order on the disc, not their order within
the group (even when group mode is on)
• Insert a disc.
Group
Group
Making a new group
with 2 groups.
Group
41
-GB