Adding Track Marks Automatically (Auto Time Stamp) - Sony Walkman MZ-S1 Manual De Instrucciones

Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused even when
the "R-Posi" is set to "Fr End".
Adding track marks
automatically (Auto
Time Stamp)
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input
connector.
Control key
(./>)
MENU/ENTER
1
While the recorder is recording or in
recording pause, press MENU.
2
Press . or > repeatedly until
"TimeMk" flashes in the display, and
then press ENTER.
3
Press . or > repeatedly until
the desired time interval flashes in the
display, and then press ENTER.
Select one of the following intervals:
Display
OFF
5 min
10 min
15 min
32
-GB
Time
—
Approx. 5 min.
Approx. 10 min.
Approx. 15 min.
To cancel Auto Time Stamp
Select "OFF", and then press ENTER in
step 3, or stop recording.
Using Auto Time Stamp to add
track marks while recording
When the elapsed recording time
exceeds the time interval for Auto
Time Stamp:
The recorder adds track marks at the point
you set the time interval and from that
point the recorder adds a track mark
whenever the time interval has elapsed.
Example: Eight minutes of recording has
been completed when the Auto Time
Stamp time interval is set to 5 minutes.
A track mark will be added at the 8-
minute point (after the start of recording)
and after each 5-minute interval
thereafter.
When the time interval set for Auto
Time Stamp exceeds the elapsed
recording time:
The recorder adds a track mark when the
set Auto Time Stamp time interval has
elapsed.
Example: Three minutes of recording has
been completed when the Auto Time
Stamp time interval is set to 5 minutes.
A track mark will be added at the 5-
minute point (after the start of recording)
and after each 5-minute interval
thereafter.
z
"T" appears before the track display on the
recorder for track marks added by Auto Time
Stamp.
Notes
• Automatic track marking by Auto Time Stamp
starts when you add a normal track mark to
the disc (i.e., by pressing T MARK or X,
etc.).
• The setting will be lost when the recording is
stopped.