Playcore Swing-N-Slide PB 9242 Instrucciones De Ensamblaje página 16

LA 6347 Bighorn_- 11/29/11 9:01 AM Page 16
Assembly Plan
Swing Beam Hardware
1. Flip 4'' x 4'' Swing Beam over so that the opposite side of your drilled holes are facing upwards.
2. Place one (1) Wood Loc Washer on each Carriage Bolt with tangs facing downward.
3. With a hammer tap bolts through drill holes in Swing Beam until tangs sink fully into the wood as shown in
(Fig. 9).
Fig. 9
4-1/2''
CARRIAGE
BOLTS
FOR SWING
HANGERS
WOOD LOC
WASHER
16