Playcore Swing-N-Slide PB 9242 Instrucciones De Ensamblaje página 18

LA 6347 Bighorn_- 11/29/11 9:01 AM Page 18
Assembly Plan
Fig. 10
A-FRAME ATTACHES
HERE
Fig. 10b
Loc Nut
Washer
4-1/4''
Swing Hanger
TWO CHILD SWING
MOUNTS HERE
x4
32-1/2''
14-1/2''
Fig. 10a
Washer
2''
Carriage Bolt
(3)
2-1/2''
screws
per bracket
(2) [PF 4024] 2'' x 4'' x 20''
Fig. 10c
Two Child Swing Supports:
1. Along top of Swing Beam mark placement for Two Child
Swing 2'' x 4'' Supports as shown in (Fig. 10).
2. Position four beam brackets (right and left) in position
on beam making certain the outside of the braces are
18'' apart and the nailing edge of the bracket is flush
with the top of the beam (Fig. 10a). Attach using three
2-1/2'' screws per bracket.
3. Attach four swing hangers to the supports using 5/16''
flat washers and loc nuts as shown in (Fig. 10b).
4. Attach using two 2'' Carriage bolts, 5/16" flat washers
and loc nuts per bracket (Fig. 10a).
5. Place Bolt Covers over the top of the swing hangers and
loc nuts. Secure to the supports using 2-1/2'' screws per
Bolt Cover, as shown in (Fig. 10c).
2-1/2'' screw
18
Loc Nut
18"
(2) 2-1/2'' screws
Bolt Cover