Transporting The Saw - DeWalt DW706 Manual De Instrucciones

OPERATING HANDLE
LOCK DOWN
PIN
0˚ BEVEL STOP
ADJ. SCREW
LEFT SIDE FENCE
CLAMPING KNOB
BENCH MOUNTING
MITER
HOLES
SCALE
(25.4mm) diameter blade hole] and against the inner
clamp washer with the teeth at the bottom of the blade
pointing toward the back of the saw.
3. Assemble the outer clamp washer onto the spindle.
4. Install the blade screw and, engaging the spindle lock,
tighten the screw firmly with wrench provided. (Turn
counterclockwise, left-hand threads)
NOTE: When using blades with a 5/8" (15.88mm) diameter
blade hole, the blade adapter will not be used and should be
stored in a safe place for future use.
5. Return the guard bracket to its original position and
firmly tighten the guard bracket screw to hold bracket in
place.
WARNING:
• The guard bracket must be returned to
its original position and the screw tight-
ened before activating the saw.
GUARD
RIGHT SIDE
BEVEL SCALE
FENCE
MITER
CLAMP
KNOB
MITER
LATCH
• Failure to do so may allow the guard to
contact the spinning saw blade result-
ing in damage to the saw and severe
personal injury.

Transporting the Saw

TURN OFF AND UNPLUG THE MITER SAW BEFORE
ATTEMPTING TO MOVE IT OR MAKE ANY ADJUST-
MENTS WHAT SO EVER!
In order to conveniently carry the miter saw from place to
place, a carrying handle has been included on the top of the
saw arm and hand indentations in the base, as shown in
Figure 4.
FIG. 2
TRIGGER
SWITCH
CARRY HANDLE
MOTOR END
CAP
MOTOR
HOUSING
DUST
SPOUT
BEVEL
LOCK
KNOB
0˚ BEVEL
OVERRIDE
KNOB
45˚ BEVEL
OVERRIDE
LEVERS
5
OPERATING
HANDLE
LEFT SIDE
FENCE
LOCK DOWN
PIN
45˚
BEVEL STOP–
BEVEL STOP–
ADJUSTMENT
33.85˚ PAWLS
SCREW
FIG. 4
HAND
INDENTATIONS
BLADE
WRENCH