Blade Recommendations; Unpacking Your Saw - DeWalt DW706 Manual De Instrucciones

Dust Bag: DW7053 (Included with some models)
Equipped with a zipper for easy emptying, the dust bag will capture the majority of
the sawdust produced. (Not shown)
NOTE: Deflector on dust spout channels debris to ground. Spout has a provision
to attach a vacuum hose to collect sawdust. Lift dust spout to connect hose.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Kerf Plate Blank: DW7055
Used to limit back side tear out of material or as a replacement kerf plate.
SAW BLADES: ALWAYS USE 12" SAW BLADES WITH 1" ARBOR HOLES. SPEED
RATING MUST BE AT LEAST 4800 RPM. Never use a smaller diameter blade. It will
not be guarded properly.
D WALT NO. OF BLADE
E
BLADE TEETH DESC.
RANGE
Series 20 40 Thin Kerf
Construction Yellow Rim
Coating
Series 20 60 Thin Kerf
Construction Yellow Rim
Coating
Series 40 40 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 60 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 80 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 80 Laser Cut Body
Woodworking Large Carbide
Teeth, Special
Tooth Geometry
Series 40 60 Laser Cut Body
Woodworking Special Tooth
Geometry
Series 40 80 Laser Cut Body
Woodworking Special Tooth
Geometry

Unpacking Your Saw

Check the contents of your miter saw carton to make sure that you have received all
parts. In addition to this instruction manual, the carton should contain:
1. One No. DW706 miter saw.
2. One D WALT 12" dia. saw blade
E
3. One blade wrench in wrench pocket shown in Figure 2.
4. One DW7053 dustbag (some models)
APPLICATION TYPE OF CUT
Gen. Purpose Smooth,
(Trim, Decking, Splinter Free
Framing)
Fine Trim Very Smooth,
Molding Splinter Free
Gen. Purpose Smooth,
(Trim, Decking, Splinter Free
Framing)
Fine Trim, Very Smooth,
Molding Splinter Free
Fine Trim Ultra Smooth,
Molding Splinter Free
Decorative
Hardwood
& Plywood
Melamines, Ultra Smooth
Veneers, Chip/Splinter
Laminates Free
Plastics, Corian® Very Smooth
and other solid Chip Free
surface materials
Non-ferrous metals Very Smooth
(aluminum, copper, Burr Free
brass, etc.)
DW7080
LOCKNUTS
END
PLATE
DW7082
3
DW7051
TOP HOLE
(USE FOR
DW706)
KNOBS
BRACKET
DW7084