Nikon EDG Manual De Instrucciones página 16

Adjusting an eyecup's position
Jp
Turn and slide eyecups
(As viewed from the eyepiece side)
En
Turn eyecup counterclockwise to
Fr
extend.
Es
Turn eyecup clockwise to retract.
There are four click positions.
● Non-eyeglass wearers:
Extend the eyecup for use (third
click position).
Note: Do not rotate eyecups
beyond the third click position as
Fully retracted position
they may detach. There are two
click positions before reaching
the fully extended position.
Position where vision is most
accurate and comfortable for
your use.
● Eyeglass wearers:
Use with the eyecups in their fully
retracted position.
If a wide, accurate view can be
obtained, you can also use the
middle click position.
Fully extended position
30
Horn-shaped rubber eyecups
● Cannot be used with
● The horn-shaped rubber
● Adjust the horns of the
Horn-shaped rubber eyecups
when mounted
Caps when mounted
Eyecap
①
eyeglasses. Please take off
your eyeglasses before use.
eyecups are attached by
covering the rubber eyepieces.
eyecups to match your
temples by observing the
following points:
・ Match the distance between
right and left eyepiece tubes
with your interpupillary
distance by moving the
tubes further apart or closer
together.
・ Set the eyecups to the fully
retracted position.
・ When mounting the
eyecups, be careful not to
change their length.
① Neckstrap eyelet
Attach the neckstrap through the eyelet for
security.
At the maximum interpupillary distance, eyecaps
are removed easily.
When the interpupillary distance is narrowed,
eyecaps are difficult to remove because of friction.
Jp
En
Fr
Es
31