KTM Power Parts 60312953000 Manual Del Usuario página 7

1
1
1
- Slide the ABS-Bad-Fuel-Dongle (1) (included) onto the mounting plate (2)
(included).
- Remove the protection cap from the diagnostics connector.
- Connect the ABS-Bad-Fuel-Dongle (1) (included) with the diagnostics con-
nector.
Properly route the cables and secure them with cable ties.
Ensure that the cables are neither kinked nor pinched.
Check the routed cables to ensure that there is no chafing.
- Mount the side cover in reverse order.
- Mount the seat.
The Adventure KTM-Dongle function is not homologated
In the Adventure, a choice can be made between 3 ABS functions.
- ABS-Mode Road (ABS lamp off):
The ABS function is active on the front wheel and rear wheel (two-chan-
nel ABS).
- ABS-Mode Offroad (flashing ABS lamp):
The ABS function is only active on the front wheel (one-channel ABS). The
rear wheel can be blocked at any time without ABS controlling the braking
procedure.
- ABS-Mode Off (permanently lit ABS lamp):
The ABS function is switched off. The front wheel and rear wheel can be
blocked at any time without the ABS controlling the braking procedure.
When the KTM-Dongle is connected and the ABS-Mode Offroad or ABS-Mode
Off is active:
After the ignition is switched off and on, the last stored
ABS-Mode stays active. The system does not automatically change to the
ABS-Mode-Road.
- The "poor fuel quality" function can be activated when the
KTM-Dongle is connected. The homologated performance is reduced accor-
ding to the fuel quality. The function may be used for no more than one
full tank of fuel.
7