Publicidad
Idiomas disponibles
Idiomas disponibles
1. HOW TO REMOVE THE AND FIT THE PEAK AND VISOR
1.1 Rotate counter clockwise the visor screw A (Pic.1) and
remove it with its own plastic washer placed between
peak and visor.
1.2 Follow the same step on the other side of helmet.
1.3 Release the peak from the shell central locking (Pic. 2)
1.4 Release the visor
1.5
To fit the peak and visor repeat the above steps in reverse.
2. INSTRUCTION TO REMOVE THE SMOKED VISOR.
2.1 Drive rearward the smoked visor lever B to remove the
smoked visor. (Pic.3)
2.2 Release the smoked visor by pulling slightly outward.
(Pic.4).
3. INSTRUCTION TO ASSEMBLE THE SMOKED VISOR
3.1 Drive rearward the smoked visor lever B.
3.2 Clip the smoked visor accommodating its side parts
into their seating slightly pressing. (Pic.5)
WARNINGS! Do not use the smoke visor during late night
hours or in scarce visibility condition.
WARNINGS! Any adjustments to the smoke visor must be
done in still position.
4. HOW TO REMOVE THE WASHABLE LINING
To remove the inner padding you can start either from the right
or left side.
4.1 Remove the cheek pad by pulling it inwards and de-
tach the studs in the back. Repeat the same step on
the opposite side (Pic.6).
6
4.2 Starting from the neck device, remove the lining by
Publicidad
