Caberg XTRACE Manual De Instrucciones página 7

pulling slightly towards the inside of the helmet (Pic.7)
until release the fixing plastic frame in the rear C. Still
pulling gently, release also the fixing plastic frame in
the front D (Pic.8).
4.3 Remove completely the lining.
5. HOW TO FIT THE WASHABLE LINING
5.1 Place the main liner padding inside the helmet.
5.2 Place the plastic frame in the front D and fix it to the
seat attached to the EPS (Pic.9).
5.3 Place the plastic frame in the rear C and fix it between
shell and EPS . (Pic.10)
5.4 Adjust the cheek pads by placing the fixing strip E be-
tween shell and EPS (Pic. 11), then hook the buttons
6. WIND STOP
The wind stop device prevents cold air entering from below.
6.1 INSTRUCTION TO MOUNT THE WIND STOP
Insert and press the fixing plastic frame of the wind
stop between the shell and the chin guard (Pic.12)
6.2 INSTRUCTION TO REMOVE THE WIND STOP
Slightly pull out the wind stop and remove it. (Pic.13)
7