Publicidad
PROBLEM
Controller not appearing in scan list or loses
connection
Visible controller, but cannot connect or stay
connected; receives Errors
Manual button press not responding
App shows running, but no watering
Automatic irrigation does not start at start time
Controller repeats cycles
Change to incorrect app passcode
Rain or Soil sensor does not suspend watering
28
CAUSE
Out of Bluetooth range.
Dead battery.
Low battery.
Incompatible smartphone.
Dead battery.
No water pressure.
Faulty or incompatible solenoid.
Connected to wrong device.
Turns on then off.
NODE-BT in System Off mode.
AM/PM or 24-hour start time not set correctly.
Water days not set correctly.
Cycle and Soak is enabled.
Sensor Alarm is detected (Soil sensor,
Clik-Delay, or Rain/Clik sensor)
NODE-BT has more than one start time assigned
to it. Each station has up to eight start times for
each of the three programs.
Cycle and Soak waters in intervals.
Forgot passcode.
Rain or Soil sensor is defective or miswired.
SOLUTION
Move in plain view of controller.
Replace the batteries (1 or 2 9V alkaline batteries).
Cycle controller batteries.
•
Reboot smartphone.
•
Reinstall Hunter NODE-BT App.
•
Reset Phone Network Settings.
•
Verify Phone and App compatibility: iOS 9.0 or
above, and Android 5.0 or above
Replace the batteries (1 or 2 9V alkaline batteries).
Turn on main system water supply.
Replace solenoid. (Must use Hunter DC latching
solenoid (P/N 458200) or other compatible DC
latching solenoid.)
Reconnect to controller.
Used AC solenoid. Must be DC solenoid.
Verify that NODE-BT is programmed for automatic
watering.
Correct AM/PM or 24-hour start time.
Correct water days (see page 18).
Disable Sensors or Station settings.
Eliminate device start times as needed.
Correct the Cycle and Soak Times in station settings.
•
Remove controller batteries .
•
Wait one minute .
•
Press and Hold Stop Station Button
inserting the batteries until Battery Check LED
turns amber.
•
Create new passcode in NODE-BT app.
Verify proper operation of the rain or soil sensor and
wire connections (see page 11).
while re-
Publicidad
