Tabla de contenido
Publicidad
3.
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit, then remove the wall plate template
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm). Be sure to drill into the center of the stud.
4.
Install wall plate assembly
against the wall plate assembly
CAUTION:
Avoid potential personal injury or property damage! Improper use could reduce the holding power of the lag bolt. DO NOT
over-tighten the lag bolts
3
using two lag bolts
21
and two washers
20
.
20
. Ensure the wall plate assembly
21
3 in. (75 mm)
7/32 in.
(5.5 mm)
19
22
. Tighten the lag bolts
is securely fastened to the wall before continuing on to the next step.
20
4
19
.
21
only until they are pulled firmly
21
22
20
13
Publicidad
Tabla de contenido
