Ega Master 79631 Manual De Instrucciones página 30

- humidity.
Pay attention that all hoses:
- Have a cross section being large enough,
- do not have any restrictions or kinks,
- are designed for a minimum operating pressure of 6 bar,
- are replaced regularly at preventative maintenance,
- have an oil resistant inner surface and an abrasion-resistant outer surface,
- are proved and specified to be non-conductive when being used next to electric conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety
requirements for use in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic impact wrench
Remove the locking cap from the air connection (see fig. 2). Connect the pneumatic hose
(not contained in the scope of delivery).
When connecting the machine, pay attention that the valve trigger 1 (see fig. 3) is not
actuated.
Blow out the pneumatic hose bevor connecting the machine. Never connect a pneumatic
hose being under pressure (see safety instructions for prevention of hazards caused by
compressed air).
30
Fig.2
STARTUP
Fig.3