Ega Master 79631 Manual De Instrucciones página 39

Remark: Some types of metal may have toxic coatings.
Please pay particular attention to avoid skin contact and breathing in, when working with
those materials. Ask your material supplier about special safety instructions and stick to them.
SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles (EN 166) – This refers to the
operator, as well as for the persons within the vicinity of the machine. Assess
and determine the grade of protection required depending on the individual
case. The risks to others should also be assessed at this time.
On overhead work, wear a safety helmet (EN 397). If a work piece,
accessories, inserted tools, or the tool itself breaks, there is danger from high
velocity projectiles.
• Before using the machine check all parts for damages.
• Replace damaged parts immediately.
• When working on brittle material make sure that you are protected against harmful splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Only use machine tools, accessories and consumables, which are recommended by the
manufacturer. Make sure choosing the correct size and the correct type. Only use accessories,
which are in proper condition and do not touch them during operation.
WARNING – Injury due to carelessness.
ATTENTION – If the machine is fixed to suspension equipment make sure
that it is secure. Never hang the machine onto the supply line.
• Separate the machine form any external energy source before changing the
machine tool or an accessory.
• Avoid direct contact with the machine tool during and after use as it can be
hot or sharp. Wear protective gloves!
Defective/ inappropriate gloves can lead to injury. Only wear proper hand
protection, adapted to the work place requirements.
WARNING – Explosion hazard!
When operating pneumatic impact wrenches in areas exposed to explosion
hazards, only use accessories, respectively devices, which are ATEX approved
and specified. Use low-sparking accessories.
39