Ega Master 79631 Manual De Instrucciones página 36

operation.
as well. Observe the following:
and hold the machine firmly and safely by hand.
machine has to be stopped instantly. It only may be re-started after having
eliminated the cause for the fault.
from sparks.
area before work is started. Among others, this relates to dust deposits,
cardboard, packing material, textile, wood and wooden splints, but also
flammable fluids and gas.
Make sure there is adequate lighting. Be extra careful in unfamiliar surroundings. There is a
risk of hidden hazards such as electric lines or other supply lines. Make sure when operating the
machine that no electrical cables, gas pipes or similar could be damaged. Use suitable and personal
SAFETY INSTRUCTIONS FOR PREVENTION OF HAZARDS
the tools (e.g. installation, changing accessories or machine tools, prior to a
long standstill, maintenance, etc.) depressurize pneumatic equipment (close
valve and depressurize pneumatic hose).
any damages and proper fixture.
When connecting / disconnecting the machine to / from the pneumatic supply, please pay
careful attention not to actuate the start lever while doing so. Never remove a pressurized
36
PROHIBITION – Eating, drinking and smoking are forbidden during
WARNING – Explosion hazard!
Operate the machine according to the intended use only.
The machine is designed for the use in areas exposed to explosion hazards
• Valid local explosion protection directives.
• Technical specifidation of the machine.
• Markings on the machine.
• Avoid the generation of sparks.
• When operating the machine, do not push or beat against other material
• Do not slide the machine over the ground.
• If heat generation exceeds the specified surface temperature, the
• The work area and the next working areas should always be protected
• Flammable and explosible material has to be removed from the work
protective equipment.
CAUSED BY COMPRESSED AIR
WARNING – Compressed air can cause severe injury. Before working on
CAUTION – Risk of injury by whipping pneumatic hose.
Check pneumatic hoses, connection components and fittings regularly for