Light Control - Ikegami ISD-A15 Manual De Instrucciones

② COLOR: The color mode can be selected.
③ B/W: The Monochrome (B/W) mode can be selected.
(4) SENS UP
Selection of electronic sensitivity increase mode. Possible to choose
electronic sensitivity increase rate.
① OFF: Electronic sensitivity increase mode is OFF.
② ON: Possible to set the maximum magnification during operation
of electronic sensitivity increase.
s 3,/7 3(544%2 X X X X X
The higher the factor, the higher the sensitivity, but motions at
maximum factor look unnatural.

(5) LIGHT CONTROL

The backlight compensation and sensing spot area modes can be
selected. The wide dynamic level and DC type iris lens are adjusted.
Select LIGHT CONTROL on the main
menu screen. Press the E button, and
the screen at right shows up.
① BACKLIGHT CMP.:
The backlight compensation
modes can be selected.
s /. .ORMAL BACKLIGHT
compensation mode is in effect.
s 30/4 3ELECT 30/4 AND PRESS
t h e E b u t t o n , a n d t h e s c r e e n
shown at right appears. Highlight
ADJUST ZONE and press the E
button, and the BLC compensation
sensing area setting screen comes
up.
Each time the E button is pressed,
the assigned area color changes in
turn Blue, Green and Red in this order.
s )N CASE OF "LUE
Using the U, D, L or R button, the field can be moved wherever
you like.
s )N CASE OF 'REEN
Using the U, D, L or R button, the field can be enlarged.
s )N CASE OF 2ED
Using the U, D, L or R button, the field can be reduced.
* To quit the field setting screen, hold down the E button longer
than 2 seconds.
www.a1securitycameras.com email: sales@a1securitycameras.com
E-7
Available from A1 Security Cameras
LIGHT CONTROL
→BACKLIGHT COMP.
W.DYNAMIC
IRIS LEVEL
LENS IRIS
RET
1SPOT ZONE
→ADJUST ZONE↓
RET
OFF
DC