Ikegami ISD-A15 Manual De Instrucciones página 9

① ­ Lens mount (CS mount)
This is used to mount the lens on the camera. Many types of CS
mount lens can be attached.
② ­ Back focus lock screw
After completing the flange back adjustment of the camera, use the
supplied Allen wrench to tighten the screw until it is fully fixed.
③ ­ Holder mounting screw holes
These holes are used to install and fix the camera on the camera
mounting or bracket. They can be also applicable to general use
tripods which have a quarter inch thread.
Note
To use these holes to attach the camera on a tripod or other
mount, make sure you use suitable size mounting bolts as
follows (1/4" -20UNC), they should not be longer than 5.5 mm to
avoid an un-stable installation.
④ ­ Auto iris lens connector
Specifically used to connect the auto iris lens.
Applicable connector: E4-191J-100 or equivalent
● DC Iris System
— Connector cable leads —
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the leads as shown above.
Please refer also to the instructions of the lens to be used.
www.a1securitycameras.com email: sales@a1securitycameras.com
2
1
3
1
2
Connector pin assignment ­
E-4
Available from A1 Security Cameras
Auto iris lens
4
3
4