Privacy Mask - Ikegami ISD-A15 Manual De Instrucciones

③ VERT: Flips the image up or down.
④ BOTH: Flips the image up and down or right and left.

(4) PRIVACY MASK

Possible to set up to 8 privacy masks.
Move to the Privacy Mask item and
press the E button to display screen to
the right.
* Note: If the camera ID is displayed
on the same line as the
privacy mask, the mask
becomes transparent. Set so
that the camera ID and mask
do not overlap.
With this screen, make On or Off of the privacy masking and desired
color of masking with PAINT, in three colors, Grey, Black or White.
While the privacy masking ON and
push E button, an individual setup
screen comes out.
With this screen, eight (8) different
individual masking can be set.
It is possible to press the E button and
set the mask position and size for the
mask of the numbers set to ON.
● Mask setting procedure
① Move the blue semitransparent cursor to the above left of the
location you wish to mask and press the E button. (If other masks
are ON, the masks other than the one being set are displayed as
grey semitransparent).
② When the cursor changes to blue, use the U, D, R, L buttons to
adjust the size.
Each button is for;
U : Moves a mask bottom line to above (Shrink height)
D : Moves a mask bottom line to below (Enlarge height)
R : Moves a mask bottom line to below (Enlarge height)
L : Moves a mask bottom line to below (Enlarge height)
③ Press the E button to display the mask section as blue
semitransparent.
If you want to change the mask position, push E button and change
the screen to a translucent sky blue screen.
If you want to change the mask size, push E button and change the
www.a1securitycameras.com email: sales@a1securitycameras.com
E-12
Available from A1 Security Cameras
PRIVACY MASK SETUP
→PRIVACY MASK
PAINT
RET
ENABLE MASKS
→MASK 1
MASK 2
MASK 3
MASK 4
MASK 5
MASK 6
MASK 7
MASK 8
RET
OFF
GRAY
ON↓
ON↓
OFF
OFF
OFF
OFF
OFF
OFF