Look RSP SEATPOST Manual De Instrucciones página 10

FITTINg ThE SADDLE TO ThE RSP ROAD STEM
1 - Position the SLIDE (4) on the head of the
SADDLE STEM (8).
2 - Fit the LOWER CLAMP (3) on to the SLIDE
+ SADDLE STEM assembly.
3 - Place the UPPER CLAMP (2) on the
LOWER CLAMP (3) . Insert SCREW (7)
in WASHER (6), and in the OBLONG
WASHER (5), and check that the serrated
sides of the 2 washers slide.
4 - Insert the three items into the
STEM+SLIDE+LOWER CLAMP+UPPER
CLAMP ASSEMBLY and screw on the
NUT (1).
5 - Fit the saddle rails on to the LOWER
CLAMP (3) then turn the UPPER CLAMP
(2), until the grooves are parallel.
6 - Slightly tighten both units with a 6 mm
hex key.
2
5
6
7
1 : Nut
2 : Upper clamp
3 : Lower clamp
4 : Slide
5 : Oblong washer
6 : Screw washer
7 : M8 1 screw
8 : Saddle stem
GB
Fig 1
1
3
4
8
9
12
10
11
13
14
9