Look RSP SEATPOST Manual De Instrucciones página 13

GB
FITTINg ThE STEM (R5 AND ROAD) INTO ThE FRAME
4 - Slide the CLAMP + BUFFER + SCREW unit
till it is stopped by the frame.
5 - Adjust the saddle's height according to
your preferences.
6 - Tighten with a 3 mm hex key SCREW M4
(3) at the advised torque of 4 N.m. Tighten
with a 4 mm hex key SCREW M5 (2) at the
advised torque of 7 N.m.
7 - Adjust the saddle horizontally with a
level and fine tune according to your
preferences.
8 - RSP ROAD:
Tighten with a 6 mm hex key screw M8 (7
FIG 1) at the advised torque of 22 N.m
RSP R5:
Tighten with a 5 mm hex key screw M5 (1
FIG 2) at the advised torque of 10 N.m.
12 12
WARNING:
By the morphology of LOOK frames,
cutting the seatpost may be necessary
in order to reach the lowest saddle
height.
To reach saddle heights (distance
between the center of the bottom
bracket & the saddle rail clamp) below
those indicated in the chart, you will
need to cut the seatpost along the limit
indicated (CUTTING LIMIT).
Size 586 RSP
XS 657
S 692
M 727
L 762
XL 792
Saddle
heights
576 RSP
-
660
730
755
785