Electrical Connection - Indesit FGIM K Manual De Instrucciones

The figures indicated on the data plate have been
calculated for this type of installation.
Ventilation
To ensure adequate ventilation, the back panel of
the cabinet must be removed. It is advisable to
install the oven so that it rests on two strips of wood,
or on a completely flat surface with an opening of at
least 45 x 560 mm ( see diagrams ).
Centring and fastening
Secure the appliance to the cabinet by opening the
oven door and fastening 4 screws into the 4 holes of
the outer frame.
! All parts ensuring the safe operation of the
appliance must not be removable without the aid of
a tool.
Electrical connections
! Ovens equipped with a three-pole power supply
cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate located on the appliance ( see below ).
Fitting the power supply cable
1. Open the terminal board by
inserting a screwdriver into the
side tabs of the cover. Use
the screwdriver as a lever by
pushing it down to open the
cover ( see diagram ).
2. Install the power supply
cable by loosening the cable
clamp screw and the three
L
wire contact screws L-N-
Connect the wires to the
corresponding terminals: the
Blue wire to the terminal
marked (N), the Brown wire to
the terminal marked (L) and
N
the Yellow/Green wire to the
terminal marked
diagram ).
3. Secure the cable by fastening the clamp screw.
4. Close the cover of the terminal board.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the
load indicated on the data plate ( see adjacent box ).
The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains. The circuit-breaker
must be suitable for the charge indicated and must
comply with current electrical regulations (the earthing
wire must not be interrupted by the circuit-breaker).
The supply cable must not come into contact with
surfaces with temperatures higher than 50°C.
! The installer must ensure that the correct electrical
connection has been made and that it is compliant
with safety regulations.
Before connecting to the power supply, make sure that:
• the appliance is earthed and the plug is compliant
with the law.
• the socket can withstand the maximum power of
the appliance, which is indicated on the data
plate ( see below ).
• the voltage is in the range between the values
indicated on the data plate ( see below ).
• the socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
GB
.
( see
15