Metabo HPT M 3612DA Instrucciones De Seguridad Y Manual De Instrucciones página 5

READ ALL INSTRUCTIONS
1. This manual contains important safety and operating
instructions for battery charger Model UC18YSL3 or
AC/DC adapter Model ET36A.
2. Before using charger or adapter, read all instructions
and cautionary markings on (1) charger or adapter, (2)
battery, and (3) product using battery.
3. To reduce risk of injury, charge metabo HPT
rechargeable battery models of the multi volt series.
Other models of batteries may burst causing personal
injury and damage.
4. Use of an attachment not recommended or sold by
the charger or adapter manufacturer may result in a
risk of fi re, electric shock, or injury to persons.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
* If the input rating of a charger or adapter is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating–for example:
1,250 watts
125 volts
8. Do not operate charger or adapter with damaged cord
or plug-replace them immediately.
9. Do not operate charger or adapter if it has received a
sharp blow, been dropped, or otherwise damaged in
any way; take it to a qualifi ed serviceman.
10. Do not disassemble charger or adapter; take it to
a qualifi ed serviceman when service or repair is
required. Incorrect reassembly may result in a risk of
electric shock or fi re.
11. To reduce risk of electric shock, unplug charger
or adapter from receptacle before attempting any
maintenance or cleaning. Removing the battery will
not reduce this risk.
12. This AC/DC adapter is for use only with specifi c tools,
including M3612DA. The adapter might be suitable for
use with other metabo HPT battery operated tools. It
is necessary to confi rm suitability by referencing the
instruction manual of the specifi c tool or by consulting
our web site https://www.metabo-hpt.com/. Failure
to confi rm suitability before using the adapter with
specifi c tools could result in fi re hazard.
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR CHARGER OR ADAPTER
but less
than
2
3
4
= 10 amperes
5. To reduce risk of damage to electric plug and cord,
pull by plug when disconnecting charger or adapter.
6. Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
7. An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fi re and electric shock.
If extension cord must be used make sure:
a. That blades of extension cord are the same
number, size, and shape as those of plug on
charger or adapter:
b. That extension cord is properly wired and in good
electrical condition; and
c. That wire size is large enough for AC ampere
rating of charger or adapter as specifi ed in Table 1.
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5) 50 (15)
18 18
18 18
18 18
IMPORTANT SAFETY INSTRUCTIONS
FOR USE OF THE BATTERY AND
CHARGER OR ADAPTER
You must charge the battery before you can use the power
tool. Before using the model UC18YSL3 battery charger,
be sure to read all instructions and cautionary statements
on it, the battery and in this manual.
REMEMBER: USE ONLY metabo HPT BATTERY
MODELS OF THE MULTI VOLT SERIES. OTHER
MODELS OF BATTERIES MAY BURST AND CAUSE
INJURY!
Follow these instructions to avoid the risk of injury:
WARNING
Improper use of the battery or battery charger
can lead to serious injury. To avoid these injuries:
1. NEVER disassemble the battery or AC/DC adapter.
2. NEVER incinerate the battery or AC/DC adapter, even
if it is damaged or is completely worn out. The battery
can explode in a fi re.
3. NEVER short-circuit the battery or AC/DC adapter.
English
100 (30) 150 (45)
18 16
16 14
16 14
5