Operational Cautions - Metabo HPT M 3612DA Instrucciones De Seguridad Y Manual De Instrucciones

English
Safeguard Function
Overload Protection
Temperature Protection
6. About remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 33, Table 6)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Remaining battery
indicator lamp
Display panel
State of lamp
Lights ;
The battery remaining power is over
75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is less
than 25%.
20
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Remaining battery
indicator switch
Fig. 33
Table 6
Battery Remaining Power
Table 5
Remove the cause of the overloading.
Allow the tool and battery to thoroughly
cool.
NOTE
○ Remaining battery levels may vary between that
shown on the battery and that of a product with its own
battery level function.
○ Do not give a strong shock to the display panel or
break it. It may lead to a trouble.

OPERATIONAL CAUTIONS

Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous work, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.
Corrective Action
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.