Chicago Faucets HyTronic 116.121.21.1 Instrucciones De Servicio página 13

Chicago Faucets HyTronic User Guide
D - Settng Scrub Mode (60 seconds)
Setting scrub mode for 60 seconds will allow the faucet to
activate for 60 seconds from the last hand presence.
Enable "Manual Setting" Mode
1
> see "Enabling Manual Setting Mode" section
Fully cover sensor with hand. Water flow stops after 5
seconds - Continue to hold on for another three (3) ad-
2
ditional water pulses
Remove hand
3
Result
Scrub Mode is now activated for 60 seconds.
E - Setting Scrub Mode (180 seconds)
Setting scrub mode for 180 seconds will allow the faucet to
activate for 180 seconds from the last hand presence.
Enable "Manual Setting" Mode
1
> see "Enabling Manual Setting Mode" section
Fully cover sensor with hand. Water flow stops after 5
seconds - Continue to hold on for another four (4) ad-
2
ditional water pulse
Remove hand
3
Result
Scrub Mode is now activated for 180 seconds.
F - Sensor Range Adjustment
The detection distance of the sensor can be adjusted be-
tween approximately 4 - 11 inches from the infrared window.
Enable "Manual Setting" Mode
1
> see "Enabling Manual Setting Mode" section
Remove all items from sink
2
Fully cover sensor with hand. Water flow will stop after
5 seconds - Continue to hold on for five (5) additional
3
water pulse
Remove hand
4
Hold hand in the current detection area until LED flas-
hes. Then move hand to the desired detection di-
5
stance. When LED stays lit for two (2) seconds,
detection distance has been re-set to new location.
Result
The detection distance is now calibrated.
G - Reset
All settings will be reset to default setting. The "Manual Set-
ting" Mode will be disabled.
The procedure for the reset is the same as "Enabling
Manual Setting Mode", but step 5 needs to be done six
(6) times in a row.
Result
All settings are reset to default settings and the manual-set-
ting-mode is now disabled.
13