Care And Maintenance Instructions; Replacing Battery - Chicago Faucets HyTronic 116.121.21.1 Instrucciones De Servicio

CARE AND MAINTENANCE
INSTRUCTIONS
Orientation
The following instructions are described in this section:
• Activating Cleaning Mode

• Replacing Battery

• Cleaning or Replacing Inlet Filter
• Adjusting Water Temperature (Internal Mixer)
• Adjusting Hot Water Limiter (External Mixer)
• Cleaning or Replacing Aerator
Activating Cleaning Mode
In order to set the cleaning mode, the faucet needs to be
have been set once into the "Manual Setting" mode. See
"Manual Setting" instructions. When cleaning mode is acti-
vated, the faucet will be inoperable for 90 seconds.
Fully cover sensor with hand, until waterflow stops.
1
(This will take approximately 5 seconds)
Remove hand
2
Result
Cleaning mode is now activated.
Replacing Battery
A traditional lavatory faucet is shown as an example. These
instructions apply to all DC models.
Prerequisites
• Battery is low (LED is lit)
• New 6 V Lithium battery (CR-P2) is required
Remove shut-off screw
1
Remove mixer handle (for faucets with external mixer
2
only)
Chicago Faucets HyTronic User Guide
Remove housing vertically
3
Remove used battery from battery holder and recycle
4
Insert new battery
5
> LED lights up for 1 second
Mount housing vertically
6
14