Installation - Chicago Faucets HyTronic 116.121.21.1 Instrucciones De Servicio

Chicago Faucets HyTronic User Guide

INSTALLATION

This faucet comes with all the components needed for instal-
lation, however, some tools and supplies are not included.
• Basin Wrench
• Adjustable Wrench
• Adjustable Locking Pliers
• Plumber´s Putty
• Hex Key (supplied)
• Aerator Key (supplied)
Do not use pipe dope on faucet and supply
connections. Possible solenoid contamination could
occur and will void any warranty.
Mounting of Lavatory and Gooseneck Faucet
Prerequisites
• Supply valve is installed
• Water supply lines are flushed properly
• For AC faucets, power outlet is installed
It is not necessary to unscrew the connection between
braided hose and housing to install the product.
Do not remove protective covering from sensor until
starting up faucet operation.
Do not tighten locknut before step 4 is completed.
Mount cover plate if required. Plumber´s putty is re-
commended to seal the cover plate to the sink.
1
Security pin must be located on the left side.
Mount gasket and put faucet into sink
2
Mount bracket from underneath. Place hoses through
large opening and mounting rod through small ope-
3
ning. Make sure flange sits securely against surface
Place nut onto mounting rod and tighten with wrench
4
If faucet was installed with cover plate, secure with
5
basin washer, flat washer and locknut
Install aerator and tighten with aerator key (supplied)
6
For Gooseneck faucets, tighten spout with wrench.
7
5