Start-Up Operation - Chicago Faucets HyTronic 116.121.21.1 Instrucciones De Servicio

Chicago Faucets HyTronic User Guide

Start-up Operation

A traditional lavatory faucet is shown as an example.
The start-up operation applies to all models.
Prerequisites
• Faucet is mounted
• Water supply is on
• Water supply lines are flushed properly
• For AC faucets, power outlet is installed
Fully open supply valves
1
Remove all items from sink
2
Remove protective covering from sensor
3
Wait for 15 seconds for the faucet to
4
calibrate to its environment
15 sec.
Result
The faucet is now activated.
Test Function
If the faucet does not work as described below, see
"Troubleshooting" section
Hold hand in front of sensor
1
- Water flow starts
Warning
Hot water may burn your skin
Hold hand carefully under water and remove quickly
For faucets with external mixer
Turn Mixer handle from cold to warm
2
- Water temperature increases
Remove hand:
3
- Water flow stops
Result
The function is now tested.
7